![]() ![]()
Now that our Wii Remote is connected to our PC, lets use another program to map out the Wii Remote inputs as keyboard inputs so that it will work PC games.ġ. If the lights look similar to the picture above, then your Wii Remote is successfully paired! If it does not have lights and it says it is paired in the Bluetooth settings, remove the device from the Bluetooth setting and try connecting it again. The Wii Remote should connect afterwards.Ĩ. If prompted for a passcode, click next without typing any numbers, then cancel. After a few seconds, its name will change into Nintendo RVL-CNT-01.)ħ. (Note: At first it may appear to be named as "Input device". Look back onto the Bluetooth window and look for a device called "Nintendo RVL-CNT-01" to pair with. Turn your Wii Remote over and click the red sync button.Ħ. ![]() Turn on your Bluetooth and keep this window open.ĥ. Locate your Bluetooth settings (can be found by searching "Bluetooth" in the windows search bar)Ĥ. (Search "program and features" in the Windows search bar) Note: If you ever want to uninstall this driver, you can do so here.ģ. Check to see if the program shows up in the list as shown in the picture above. WII MOTION PLUS EMULATOR MAC DRIVERAfterwards, check in your programs and features to see if the driver installed correctly. Note: Admin rights are needed to run this program.Ģ. WII MOTION PLUS EMULATOR MAC INSTALLRun the "TinyInstaller.exe" to install the actual driver. WII MOTION PLUS EMULATOR MAC DRIVERSSo, with the drivers all downloaded and your PC off of driver signature enforcement (for 64-bit only), now all we need to do is connect your Wii Remote to your PC!ġ. (Search CMD in the bottom left Windows Search Bar)ģ. If you would like to disable driver signature enforcement permanently, you can do so by following the steps below.įor PERMANENT disabling of driver signatures, you do the following:ġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |